How to set up the nJoy thermostat without using the App.
Important: This is for the initial setup only. Scheduling/programming requires a Bluetooth or Wifi connection and the nJoy App
With Power On. Press the Center Square Icon on the face of the thermostat. The thermostat Start-Up Wizard will then step through the thermostat default settings:
UN - Unit.
. Press Circle to select.
. Arrow to F (Fahrenheit) or C (Celsius).
. Press Circle to select.
. Arrow Down to the next setting.
SE - Sensor.
. Press Circle to select.
. Arrow to F (Floor), R (Room), or RF (Room/Floor).
. Press Circle to select.
. Arrow Down to the next setting.
Ti - Time.
. Press Circle to select.
. HH - Hour.
. Arrow to the correct Hour.
. Note: The 2 small dots on the left indicate AM (top) or PM (bottom). The clock is in 12-hour format.
. Press Circle to select.
. Mi - Minute.
. Arrow to the correct Minute.
. Press Circle to select.
. Arrow Down to the next setting.
PR - Protection.
. Press Circle to select.
. Arrow to W (Wood), T (Tile), or L (Laminate).
. Press Circle to select.
. Arrow Down to the next setting.
TE - Test GFCI.
. Depress the button on the outside top of the thermostat to trip the GFCI.
. Depress the lower right side button on the outside of the thermostat to reset the GFCI.
The nJoy will then save these new default settings and display the current temperature.
To adjust temperature, wake up the thermostat by touching the screen and arrowing to the desired heated temperature. Once selected, it will blink a couple of times and then revert to the sensed current temperature on the display before going back to sleep. Note: An orange LED will come on when the thermostat is energizing the heaters.